Article number
000002927
Affected Versions
All
Source Hypervisor
All
Target Hypervisor
All

How to Start a Force Sync

Viewed 1219 times

Summary

An administrator may need to ensure that volumes on the protected and recovery sites are fully synchronized and consistent with one another. To do so, a Force Sync should be ran on the suspect VPGs.

Steps

To run a force sync operation kindly follow the steps below: 

  1. Login to the ZVM GUI.
  2. Navigate to the VPG's tab within the Zerto GUI.
  3. Select the VPG you wish to synchronize. 
  4. Select More.
  5. Select Force Sync.