Zerto Virtual Replication Between vSphere 4.x and 5.x Environments

KB Number:
00000045

Solution:

Purpose


When working with Zerto Virtual Replication between environments differing in ESX/ESXi versions, it is important to keep in mind the Virtual Hardware Version.  This limitation is imposed by the VMware infrastructure and not by Zerto Virtual Replication.  This article outlines the VMware software requirements for Zerto Virtual Replication as well as the impact of replicating between environments differing in ESX/ESXi versions.

 

 

Affected Versions


All versions

Complexity


Low

 

 

Solution


As of 2.0 Update 1 (Viper), Zerto Virtual Replication requires the following VMware software:

  • ESX/ESXi 4.0U1 or greater
  • vCenter Server 4.0 or greater
Under ESX/ESXi 4.0, Virtual Hardware Version 4 is supported.
Under ESX/ESXi 4.1, Virtual Hardware Versions 4 and 7 are supported.
Under ESXi 5.0, Virtual Hardware Versions 4, 7 and 8 are supported.
Under ESXi 5.1, Virtual Hardware Versions 4, 7, 8 and 9 are supported.
Under ESXi 5.5, Virtual Hardware Versions 4, 7, 8, 9, and 10 are supported.
For explanatory purposes, the following points apply to a VM created as Virtual Hardware Version 8 on an ESXi 5.0 host:
  • If the VM was failed over to a site with an ESXi 5.1 host, there would be no issue - the ESXi 5.1 host supports Virtual Hardware Version 8, as well as 4, 7, and 9.
  • If the VM was failed over and reverse protection was enabled, this would also work as expected - the ESXi 5.0 host could still act as the target for replication as the VM is of Virtual Hardware Version 8.
  • If after failover to the ESXi 5.1 host, the VM was upgraded to Virtual Hardware Version 9, ZVR would not be able to maintain replication back to the ESXi 5.0 host.  This is because the ESXi 5.0 host can only support Virtual Hardware Versions 4, 7 and 8.

1 Star2 Stars3 Stars4 Stars5 Stars (No Ratings Yet)
Loading...